A Shewhart chart (also called a control chart) is the foundational Statistical Process Control (SPC) tool that plots individual measurements or subgroup statistics over time against control limits to determine whether a process is stable and in control. Developed by Walter Shewhart in the 1920s, it remains the most widely used SPC method in manufacturing.

How a Shewhart Chart Works

• Data Points: Each point on the chart represents a measurement (individual value, subgroup mean, range, or proportion) taken at a specific time.
• Center Line (CL): The process mean ($\bar{X}$) — the expected value when the process is in control.
• Upper Control Limit (UCL): $\bar{X} + 3\sigma$ — the upper boundary of expected natural variation.
• Lower Control Limit (LCL): $\bar{X} - 3\sigma$ — the lower boundary.
• Decision Rule: If a point falls outside the control limits, the process is out of control (OOC) — an assignable cause should be investigated.

Types of Shewhart Charts

• X-bar Chart: Plots subgroup means — monitors the process average.
• R Chart (Range): Plots subgroup ranges — monitors process variability.
• S Chart (Std Dev): Plots subgroup standard deviations — alternative to R chart for larger subgroups.
• I-MR Chart (Individuals and Moving Range): For single measurements without subgroups — common in semiconductor applications where each wafer produces one measurement.
• p Chart: Monitors proportion defective.
• c/u Charts: Monitor defect counts.

Western Electric Rules (Run Rules)

Beyond the basic "point outside 3σ" rule, additional patterns indicate out-of-control conditions:

• Rule 1: 1 point beyond 3σ.
• Rule 2: 2 of 3 consecutive points beyond 2σ (same side).
• Rule 3: 4 of 5 consecutive points beyond 1σ (same side).
• Rule 4: 8 consecutive points on one side of the center line.
• These rules detect trends, shifts, and runs that a single-point test would miss.

Semiconductor Applications

• CD Monitoring: Track critical dimension lot-to-lot or wafer-to-wafer.
• Film Thickness: Monitor deposition uniformity and mean thickness.
• Etch Rate: Track etch rate stability between maintenance cycles.
• Overlay: Monitor lithographic alignment accuracy.
• Defect Counts: Track particle and defect levels per chamber.

Strengths and Limitations

• Strengths: Simple, intuitive, well-understood, easy to implement.
• Limitations: Poor sensitivity to small, gradual shifts (<1.5σ) — EWMA or CUSUM charts are better for drift detection.

The Shewhart chart is the bedrock of SPC in semiconductor manufacturing — every fab uses them extensively, and understanding their principles is fundamental to process engineering.