ESD HBM Cdm

HBM and CDM are the two standard models used to qualify a chip's electrostatic discharge (ESD) protection, and they simulate two completely different real-world events: a charged person touching a pin versus a charged chip discharging through a pin as it touches a grounded surface.

HBM: a charged person touches a pin
slow discharge, hundreds of nanoseconds
CDM: a charged chip touches ground
fast discharge, under two nanoseconds
Each event stresses the protection circuit differently
HBM tests moderate current over a longer pulse
CDM tests extreme peak current over a much shorter pulse
Chip must pass both models to qualify
a design that survives one can still fail the other

These two models exist because ESD damage doesn't happen just one way, and a protection circuit tuned for one event can still be dangerously exposed to the other. A person walking across a carpet can build up a static charge and discharge it through a pin the moment they touch a chip or a board — that's the human body model, and it's been the industry's reference ESD threat for decades. A chip sliding down a shipping tube or across an assembly line can pick up its own static charge independent of any person, and then discharge that charge almost instantly the moment a pin touches a grounded surface — that's the charged device model, and it became a serious qualification concern specifically because modern packages and handling automation made this exact kind of self-charging event common.

Two Very Different Discharge Pulses same chip, two completely different stress events HBM — human body model moderate peak current decays over ~150 ns typical pass level: 2 kV CDM — charged device model extreme peak current over in under 2 ns typical pass level: 500 V CDM's pulse is far shorter but its peak current is far higher a protection circuit fast enough for CDM is a different design problem than one sized for HBM

Those two pulse shapes demand genuinely different protection circuit designs, which is why passing one model says very little about the other. HBM's slower, longer pulse gives a protection device time to turn on and conduct current away from sensitive circuitry, so an ESD clamp optimized for HBM can afford to be a bit slower to respond; CDM's pulse is over before a sluggish protection device can even finish turning on, which means CDM protection has to react in a fraction of the time and survive a much higher instantaneous current — a chip can pass a comfortable HBM qualification while still failing CDM, or vice versa, because the two events are stressing fundamentally different things about the same protection circuit.

HBMCDM
What it simulatesA charged person touching a pinA charged chip discharging through a pin
Discharge speedSlower, roughly hundreds of nsExtremely fast, under 2 ns
Peak currentModerateVery high
Governing standardJEDEC JS-001 / ANSI-ESDAJEDEC JS-002
Typical qualification level~2 kV~500 V
Dominant risk sourceHuman handlingAutomated assembly, shipping, handling

CDM became a serious qualification concern specifically because the industry's own manufacturing automation created more opportunities for it, not because the physics changed. Older, more manual assembly processes gave parts more chances to pick up and bleed off static charge gradually, while modern high-speed automated handling — tape-and-reel feeders, pick-and-place equipment, shipping tubes — moves parts fast enough that a chip can build up significant charge on its own and then discharge it violently the instant a pin contacts a grounded surface, which is exactly the event CDM is built to simulate; design teams now treat CDM robustness as at least as important as HBM, and often harder to achieve given how little time the protection circuit gets to react.

Read HBM and CDM through a different-villain lens rather than a stricter-vs-looser lens: HBM asks whether a chip survives a charged person, CDM asks whether it survives its own charge discharging through automated handling, and because those are physically different events with different pulse shapes, a chip's ESD protection has to be designed — and qualified — against both separately before it's trusted to ship.

Take ESD HBM CDM further

Ask the copilot about this term, or have our engineers assess it against your process.