Schottky Ttl 1970s Clamp the Base Collector Junction Instead of Avoiding Saturation
# Schottky TTL (early 1970s): Step 2 — Clamp the Base-Collector Junction Instead of Avoiding Saturation
Clamp the Base-Collector Junction Instead of Avoiding Saturation. Rather than redesigning the circuit topology to avoid saturation (ECL's route), Schottky TTL's designers asked a narrower question: can a transistor be prevented from reaching hard saturation while keeping everything else about the TTL gate unchanged? The answer was to place a diode directly between each transistor's base and collector terminals, oriented so that as the base-collector voltage approaches the diode's forward turn-on voltage, the diode begins conducting and diverts excess base drive current away from the base, into the collector, before the base-collector junction itself can forward-bias enough to inject significant minority carriers into the base region.
## 1. The Clamping Insight
Rather than redesigning the circuit topology to avoid saturation (ECL's route), Schottky TTL's designers asked a narrower question: can a transistor be prevented from reaching hard saturation while keeping everything else about the TTL gate unchanged? The answer was to place a diode directly between each transistor's base and collector terminals, oriented so that as the base-collector voltage approaches the diode's forward turn-on voltage, the diode begins conducting and diverts excess base drive current away from the base, into the collector, before the base-collector junction itself can forward-bias enough to inject significant minority carriers into the base region. The transistor is held at the edge of saturation — collector current still flows, V_CE still drops to a low value — but the charge-storage mechanism that causes t_s never substantially develops, because the base-collector junction of the transistor itself stays essentially unbiased.
## 2. Real Diagram: Clamped Transistor Cross-Section and Clamp Action
## 3. Clamping, Not Avoidance: Why the Distinction Matters
The clamping approach is deliberately conservative relative to ECL's avoidance approach: it modifies an existing, well-understood TTL transistor's local behavior rather than replacing the surrounding circuit topology. That conservatism is exactly why it was commercially attractive — a Schottky-clamped TTL gate still presents the same input thresholds, the same 5 V supply requirement, the same totem-pole output structure, and the same pinout conventions as standard TTL, so a designer could substitute 74S or 74LS parts into an existing TTL board with no interface redesign. The next several steps work through why the clamp has to be a Schottky (metal-semiconductor) diode specifically, rather than an ordinary silicon p-n diode, and how adding that diode changes the underlying bipolar process.
## 4. Companion Diagram: Stage Sequence and Trend Summary
## Clamp the Base-Collector Junction Instead of Avoiding Saturation's Place in the Process Lineage
This is step 2 of 20 in the Schottky TTL (early 1970s) series, introducing the base-collector clamp that distinguishes Schottky TTL from both standard TTL and ECL's non-saturating approach.