SiC Process
The SiC process deposits silicon carbide — most often as a thin PECVD barrier and etch-stop film in copper BEOL, occasionally as a bulk crystalline substrate for power devices, two uses that share a name but almost nothing else. In the interconnect stack, SiC (and its nitrogen- and oxygen-doped cousins, SiCN and SiCO) exists to do a job copper created and silicon nitride used to do less well: keep copper atoms from diffusing into the surrounding dielectric without dragging the stack's overall dielectric constant back up.
Silicon nitride was the obvious first choice for a copper barrier, and copper BEOL's own dielectric-constant budget is exactly why SiC replaced it. SiN blocks copper diffusion extremely well, but its dielectric constant (roughly 7) is high enough that a nitride cap sitting between every pair of copper metal levels adds up to a real capacitance penalty across a BEOL stack already fighting to keep RC delay down. SiC's dielectric constant (roughly 4.5–5, and lower still for SiCO variants) gives up some of SiN's absolute barrier performance in exchange for a meaningfully lower capacitance contribution — a trade worth making once low-k interlayer dielectrics made every stray high-k film in the stack a measurable speed cost.
The same film also functions as the via etch stop, which is a mechanical job, not a diffusion-barrier job, and that dual role is why the layer can't be skipped. When a via is etched down to connect to a buried copper line, the etch chemistry has to stop precisely at the copper surface without punching through — an SiC/SiCN cap with strong etch selectivity against the surrounding low-k dielectric gives that etch a hard, reliable stopping point. Removing the barrier layer wouldn't just reopen the copper-diffusion risk; it would also remove the only feature in the stack that tells a via etch exactly where to stop.
Bulk crystalline silicon carbide is an almost entirely separate process, grown as a wide-bandgap power-semiconductor substrate rather than deposited as a thin dielectric film. 4H-SiC wafers, grown by physical vapor transport (a seeded sublimation process closer to crystal growth than thin-film deposition) and then epitaxially thickened, serve as the substrate for SiC power MOSFETs and Schottky diodes used in EV inverters, fast chargers, and grid power electronics — chosen over silicon for a roughly 10x higher critical electric field and far better high-temperature operation, properties that come from the same strong Si-C bond that makes the thin-film barrier version so good at blocking diffusion in the first place.
Read the SiC process as one material doing two unrelated jobs under two unrelated process technologies: a few tens of nanometers of PECVD SiC caps every copper level in a modern BEOL stack as a combined diffusion barrier and etch stop, while a wafer's thickness of crystal-grown SiC underlies an entirely different device family built for power levels copper interconnect will never see — and both uses trace back to the same strong, stable Si-C bond.