Carbon Process
The carbon process deposits amorphous carbon — a disordered film of sp2 and sp3-bonded carbon atoms, grown from a hydrocarbon precursor plasma, with no long-range crystal structure at all. It's the generic technology underneath trade names like Applied Materials' APF; every equipment maker sells some version of it, because the underlying property any fab actually wants — a sacrificial film that's simultaneously hard to etch and trivial to remove completely — doesn't depend on whose chamber grew it.
The property that actually matters is the ratio of sp3 to sp2 bonding, not the deposition rate. Carbon atoms bonded in a diamond-like sp3 tetrahedral arrangement produce a dense, hard, highly etch-resistant film; carbon bonded in graphite-like sp2 sheets produces a softer, more easily consumed film with weaker mechanical properties. A PECVD carbon process tunes this ratio mainly through ion bombardment energy during growth — higher RF bias accelerates ions into the growing film hard enough to favor the denser sp3 bonding, the same mechanism that lets diamond-like carbon (DLC) coatings be grown from the same basic chemistry family for entirely different applications like wear-resistant coatings. A hard-mask-grade carbon film sits deliberately toward the sp3-rich end of that spectrum; a sacrificial planarization layer, where etch resistance matters less than gap-fill and removability, can sit further toward sp2.
That sp3/sp2 tunability is why the same base chemistry serves jobs beyond patterning. A denser, harder carbon film makes a good mandrel for self-aligned multiple patterning (the spacer process relies on a sacrificial core with exactly this etch-and-strip profile) and a good hard mask for deep, demanding etches; a softer, more gap-filling carbon film is chosen instead when the job is planarizing severe topography ahead of lithography, where mechanical hardness matters less than the film's ability to flow and fill. Spin-on carbon occupies a related but distinct niche — applied as a liquid and baked rather than grown from plasma — trading some of PECVD carbon's density and etch resistance for better gap-fill on the roughest topography and a lower deposition-tool cost.
Removability is the property that makes this whole family of processes viable at all, and it's not automatic. A metal or nitride hard mask leaves residue that needs its own dedicated clean; amorphous carbon's defining advantage is that an O2 plasma ash converts the entire film to CO and CO2 and pumps it away with nothing left behind — but only if the film's density and the ash chemistry are matched correctly. An overly dense, highly sp3-bonded film resists the O2 ash nearly as stubbornly as it resisted the patterning etch, so production recipes tune bonding as a two-sided target: resistant enough to survive the etch it's protecting, removable enough to strip cleanly afterward without an extended, risky over-ash.
Read the carbon process as the demonstration that a material family can be engineered along a single dial — ion energy during growth, which sets the sp3/sp2 ratio — to serve opposite jobs in the same fab: hard and etch-resistant where a mask or a mandrel needs to survive aggressive plasma, soft and flowable where the job is burying topography, and in every case gone completely the moment an O2 ash is struck.