die bonding

Die bonding (die attach) is the assembly process of **picking individual semiconductor dies** from a diced wafer and placing them onto a substrate, leadframe, or another die with precise alignment and permanent attachment. **Bonding Methods** **Epoxy die attach**: Adhesive paste dispensed on substrate, die placed and cured at 150-175°C. Most common for standard packages. **Eutectic die attach**: Die bonded using a solder alloy (AuSn, AuSi) that melts and solidifies at a specific temperature. Superior thermal conductivity. Used for high-power and RF devices. **Film adhesive (DAF)**: Die Attach Film pre-applied to wafer backside before dicing. Clean, uniform bondline. Common in memory stacking. **Direct bonding**: Oxide-oxide or Cu-Cu bonding for 3D integration. No adhesive—atomic-level bonding. Used in advanced 3D stacking (e.g., **AMD 3D V-Cache**). **Process Steps** **Step 1 - Wafer Mount**: Diced wafer on tape frame loaded into die bonder. **Step 2 - Die Inspection**: Vision system inspects each die for defects, reads ink marks or e-test maps to skip bad dies. **Step 3 - Die Eject**: Needles or laser push die up from tape backside. **Step 4 - Pick**: Vacuum collet picks the die from the tape. **Step 5 - Place**: Die aligned to substrate using pattern recognition and placed with controlled force. **Step 6 - Cure/Reflow**: Epoxy cured or solder reflowed to complete the bond. **Key Specs** • Placement accuracy: **±5-25μm** (standard), **±1-2μm** (advanced 3D bonding) • Throughput: **2,000-30,000 units per hour** depending on accuracy requirements