Sacvd Process
The SACVD process deposits silicon dioxide at sub-atmospheric pressure — roughly 100–600 Torr, well below standard atmospheric CVD but well above LPCVD's near-vacuum — using ozone and TEOS as the reactant pair. It occupies a specific pressure window chosen for one property almost no other oxide deposition technique matches: the film flows into a trench before it fully solidifies, filling gaps that would pinch shut and void under a purely conformal deposition.
The pressure window is the whole trick, not a side detail. At atmospheric pressure, the ozone-TEOS reaction runs too fast and particulate-prone to control well; at LPCVD's low pressure, the reaction slows down enough to behave like ordinary conformal CVD, losing the flow property entirely. Sub-atmospheric pressure sits in the narrow middle ground where the reaction is fast enough to deposit efficiently but gentle enough that the as-deposited film retains enough mobility to migrate laterally into a gap before it sets — closer to a self-leveling liquid settling into a mold than to a film growing atom by atom on every surface equally.
That flow behavior made SACVD the default for pre-metal dielectric, the layer with the narrowest, most unforgiving gaps on the whole chip. Pre-metal dielectric (PMD) has to fill the spaces between densely packed polysilicon gates and local interconnect before the first metal layer goes down, and those gaps were often narrower and more aspect-ratio-demanding than anything else in the flow. Borophosphosilicate glass (BPSG) deposited by SACVD, followed by a reflow anneal that softens the boron- and phosphorus-doped glass just enough to smooth its own surface, became the standard PMD combination for exactly this reason — SACVD's flow property gets the gap filled void-free, and the reflow step finishes planarizing what SACVD alone couldn't perfectly flatten.
Ozone concentration, not just pressure, is the dial that tunes flowability. A higher ozone-to-TEOS ratio produces a more mobile, flow-prone film but also one that's more hygroscopic — it absorbs moisture readily, which can cause popping, outgassing, or adhesion failures in later high-temperature steps if the film isn't properly capped or densified. Production SACVD recipes spend as much engineering effort tuning that ozone ratio and the post-deposition densification anneal as they do tuning the raw deposition rate, because a film that fills every gap perfectly but later outgasses during a subsequent anneal has only moved the defect downstream rather than eliminating it.
SACVD and TEOS cover different jobs in the same dielectric stack, not competing ones. TEOS (LPCVD or PECVD) gives excellent step coverage on moderate topography and runs at lower thermal budgets where needed, but it can't flow into the tightest, most aggressive gaps the way SACVD can; SACVD's ozone-TEOS chemistry buys gap-fill performance at the cost of a narrower process window and a hygroscopic film that needs careful follow-up treatment. A real BEOL flow typically uses both — SACVD or an equivalent flowable chemistry where the gap genuinely demands it, and simpler TEOS oxide everywhere the topography is forgiving enough not to need it.
Read SACVD as proof that pressure itself can be a process lever, not just a side condition to hold steady: the same ozone-TEOS chemistry that behaves like ordinary CVD at either extreme becomes something closer to a self-leveling liquid in the narrow sub-atmospheric window, and that one property — flow before set — is the entire reason SACVD exists as a distinct process rather than a footnote to plain TEOS deposition.